Frigidaire Range F10 Error Code

An oven showing F10 has detected a temperature higher than normal. Frigidaire calls it a built-in safety alert meant to protect the appliance and keep operation safe. It is listed as “Thermal Runaway” in the owner support guide and as “Runaway Temperature” on the fault code sheet.

Standard ranges and wall ovens

1. Shut the oven off and wait for it to cool before the next use.
2. To reset, pull the plug for 30 seconds and then reconnect it.
3. When the plug is out of reach, the breaker works as a reset too, though everything on that circuit resets with it.

If F10 persists, contact support.

Stone-baked pizza ovens

These models can throw F10 when the Pizza Shield is set in the wrong rack position. Rack position 7 is where both the oven rack and the Pizza Shield belong, though some models vary, so the Use and Care Guide has the final word. After that, reset the unit and begin the Stone-Baked Pizza preheat over.

What a technician checks

The fault code sheet lists the RTD sensor probe first, replacing it if necessary. If the oven keeps overheating after power is reapplied, the electronic oven control is the next suspect.

Related codes

• F2 is the older code for oven temperature above specification.
• F30 is an open oven probe connection.

Frigidaire range service in Los Angeles

For a Frigidaire oven that keeps showing F10 in Los Angeles, call (310) 861-3938. Say what you tried, give the model number, and note whether the oven was in a pizza mode. The range repair page has more.

Source: Troubleshooting Frigidaire Ranges or Ovens with Electronic Oven Controls (EOC), fault code sheet; Frigidaire owner support: Ranges – Error Code Guide; Frigidaire owner support: Oven Error Codes and Alarms Guide